4 sources, 3 tags

Beginner FAQ

Why Does My Laser Stop in the Middle of a Job?

When a laser run from LightBurn quits partway through, the usual cause is a dropped USB connection or a brief power dip, not the design file. Here's what LightBurn's troubleshooting guides say to check.

If your laser starts a job fine and then just stops, with the head parked and maybe only the fans still running, the most likely cause is that the connection between the computer and the laser dropped, or the controller lost power for a moment. LightBurn’s documentation says lost USB connections are relatively common and can be caused by the controller, the computer, the cable or the power around them.

Read what LightBurn tells you

Start by checking whether LightBurn showed a “Connection lost” message. LightBurn says that message means the USB connection was dropped by either the controller or the computer. On GRBL lasers, also look in the Console window for errors or alarms, and if your machine has its own screen, check it for messages.

LightBurn also notes that a laser which seems to restart on its own, for example homing unexpectedly when it’s set to home at startup, usually points to communication problems or a brief loss of power.

Some enclosed lasers won’t keep running with the lid open, and some water-cooled lasers stop if they don’t detect water flow. LightBurn lists both as reasons a connected laser may not respond, so rule them out first.

Check the USB cable and port

LightBurn’s USB guide recommends trying a better-shielded cable, especially if you’re still using the one that came with the laser, because poor shielding lets electrical noise interfere with the signal. A few other points from the guide:

  • Keep USB cables to 3 meters (16 feet) or less. For longer runs, LightBurn suggests an active extender, Ethernet on Ruida controllers, or WiFi on GRBL lasers that support it.
  • Some lasers have trouble with USB-C to USB-C cables. LightBurn names the Sculpfun iCube, Creality Falcon and Ortur LM3, and says to use a USB-A to USB-C cable instead, with an adapter or hub if your computer has no USB-A port.
  • Try a different USB port, since ports can fail without visible damage.
  • Route the USB cable away from the stepper motors and anything else that could cause interference.

Turn off USB power saving on Windows

If the connection works at first and drops after a while, LightBurn says Windows may be putting the “idle” USB port into power-save mode. This is most common on laptops. LightBurn’s Windows guide walks through turning off USB selective suspend in Power Options, and on a laptop you need to change it for both the battery and plugged-in power plans.

Look at power and grounding

LightBurn’s electrical guide lists two more causes:

  • Shared circuits. A chiller or external air assist on the same circuit can cause a small power drop that makes the laser brown out and disconnect or reset. LightBurn suggests putting the laser on its own breaker if you can.
  • Static. If the laser’s metal parts aren’t bonded together and grounded, static can build up on the head or rails and discharge through the USB connection. LightBurn says this is especially common on belt-driven lasers with plastic wheels.

If you’ve worked through all of this and the laser still stops, the LightBurn guides below have more detail, and your laser maker’s support team can check the controller and power supply.

Sources

About This Tinkerverse

The Tinkerverse

Lasers, maker tools and whatever else catches a tech geek's curiosity. News, how-tos and projects from The Tinkerverse.

Version
Always tinkering
Memory
640K of curiosity
Status
Probably mid-project
About pageYouTube
Control Panel

Saved on this device

Display

Desktop color

Desktop pattern

Trash

9 items

Secure Access
Command Prompt